Specifications

Platinum Beam 15R™
©Elation Professional® Los Angeles Ca. 90040 www.ElationLighting.com
22
9. CONTROL BOARD
The Control Board offers several features: you can simply set the starting address, run
the pre-programmed program or make a reset.
The main menu is accessed by pressing and holding down the -button until the
display starts flashing. Browse through the menu by pressing the -button,
-button, -button or -button. Press the Enter-button to select the desired
menu function. You can change the selection by pressing the -button,
-button, -button or -button. Confirm every selection by pressing the
-button. You can exit the menu at any time by pressing the -button. The functions
provided are described in the following sections. it will exit from flash 10 seconds after the
last key function has been pressed. The fixture menu commands and functions are
described in the following section.
To access the display menu via the internal battery, press the DC switch button
for 2seconds; To shut off the display immediately, choose the commend " Reset
All" menu and press "Enter" button, otherwise, the display will automatically
switch off about 1 minute from last button press.
Function
Set Dmx Address
Dmx Value
Slave Mode
Auto Program
Sound Control
A001~AXXX
PAN……
Slave1,Slave2,Slave3
Master / Alone
Master / Alone
DMX address
setting
DMX value display
Slave setting
Auto program
Music control
Information
Time
Information
Current Time
Total Run Time
Last Run Time
Lamp Hours
Lamp Off Time
LastRun
Password
Clean Last Run
LampTime
Password
Clean Lamp Time
XXXX(Hours)
XXXX(Hours)
XXXX(Hours)
XXXX(Hours)
XXXX(Minute)
Password=XXX
ON/OFF
Password=XXX
ON/OFF
Power on running
time
Fixture running time
Fixture Last times
clear
Lamp running time
Lamp off time
Timer Password
038
Clear Fixture Last
time
Lamp Password