Integration Manual

Abbildung 1: Dimensions and pinout of TWN4 MultiTech M

MECHANICAL INSTALLATION

There are 4 holes for mechanical fixation of the board, see Abbildung 1: Dimensions and pinout of TWN4 MultiTech M

ELECTRICAL CONNECTION

The module can be connected via USB, RS232 and other interfaces see Abbildung 1: Dimensions and pinout of TWN4 MultiTech M

The input voltage is 4.3V to 5.5V.

FURTHER REQUIREMENTS

-Label requirements

Using a permanently affixed label, the TWN4 MultiTech M must be labeled with an own FCC identification number. In case this label

is not visible anymore after integration of the TWN4 MultiTech M in the host device, it is necessary to bring a label on the host device

(on a visible and accessible place) stating the FCC identification number of the integrated TWN4 MultiTech M.