Integration Manual

© 2020 ELATEC GmbH – IM TWN4 MultiTech M – 12/2020 Page 3 of 8
INTRODUCTION
ABOUT THIS MANUAL
This integration manual explains how to integrate ELATEC RFID module TWN4 MultiTech M into a host device and is mainly
intended for integrators and host manufacturers.
The content of this integration manual is subject to changes and printed versions might be obsolete. As the module manufacturer,
ELATEC is responsible for the update, release and publication on the FCC database of this integration manual. The integrators and
host manufacturers are required to use the latest integration manual published by ELATEC on the FCC database.
ELATEC, integrators and host manufacturers are liable for any failure to observe these requirements.
SAFETY NOTES
- ELATEC TWN4 MultiTech M is an electronic component and should be installed exclusively by a trained and qualified personnel.
- ELATEC recommends the integrators to follow general ESD protective measures during the installation of the TWN4 MultiTech M
in a host device, e.g. the use of an antistatic wristband or special gloves.
- The integrator should not touch the antennas (if not shielded), printed circuit boards, connectors or other sensitive components on
the TWN4 MultiTech M.
- Before installing the TWN4 MultiTech M in a host device, the integrator should also make sure that he/she has read and
understood the technical documentation of the host manufacturer related to the host device.
TERMS AND DEFINITIONS
Term
Definition
host device
Also “host” or “host product”. Device in which an RFID module is intended to be installed for operation.
integrator
Responsible party for the integration of an RFID module into a host device. The integrator might be
the module manufacturer, the host manufacturer, the end user or any other third party.
modular type
Physical configuration in which a modular transmitter operates when installed within a host device. It
can be a single-modular, a limited single-modular, a split-modular or a limited split-modular type.
RFID module
Device intended to be used within another device or product. Depending on the equipment
configuration and intended use, an RFID module has to meet different requirements to get a modular
grant.
RELEVANT DOCUMENTATION
ELATEC documentation
TWN4 MultiTech M data sheet
TWN4 MultiTech M functional description
TWN4 MultiTech M technical handbook
TWN4 MultiTech M user manual
External documentation
Document name
Document title/description
Source
n/a
Technical documentation related to the
host product
Host product manufacturer
784748 D01 General labeling and
Notification
General Guidelines for Labeling and
Other Information Required to be
Provided to Users
Federal Communications Commission
Office of Engineering and Technology
Laboratory Division
996369 D01 Module Equip Auth Guide
Transmitter Module Equipment
Authorization Guide
Federal Communications Commission
Office of Engineering and Technology
Laboratory Division
996369 D02 Module Q and A
Frequently Asked Questions and
Federal Communications Commission