User Manual

Silent button design
The silent micro switch design, produce sounds can be reduced about 95%
than the other mouse, the service life reach more than 3000000 times.
Quick start guide:
Open the battery case, insert the battery to the case(pay attention the
positive and negative position)
Note: Before you use it, please tear the battery insulating protective film
Remove the receiver
Insert the receiver into the computer USB interface
Data parameter
Frequency: 2402MHz —2480MHz (2.4G)& 2402MHz —2480MHz(LE) Dual mode
Channel:16 /40
Data transmission: 2 Mbps / 1 Mbps
Distance: 15m Max
Voltage: DC1.5V
Current: 11mA
Mouse key life: 300 millions Above
Size: 113*64*32mm
Weight: 64g
System requirement:
IBM or compatible computer:
Windows: 2000/ME/XP(*64)/Vista/7/8/10
Mac OS X(V10.4 above)
Workable USB port
Warning:
Changes or modifications to this unit not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment.
NOTE
This device complies with part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) This device may not cause harmful interference, and (2) this device must accept
any interference received, including interference that may cause undesired operation.
NOTE
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates, uses and can
radiate radio frequency energy and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one or more of the following
measures:
—Reorient or relocate the receiving antenna.
—Increase the separation between the equipment and receiver.
—Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
—Consult the dealer or an experienced radio/TV technician for help.
RF exposure compliance statement:
This device has been evaluated to meet the general RF exposure requirement
it can be used in portable exposure condition without restriction.