User`s guide

InterProxy VBN configuration 4-9
Software Release 2.30 YesWare Applications User’s Guide 08-01016-01
Procedure 4-1
Configuring the InterProxy network connection
Use this procedure to configure the InterProxy/ETH 1 interface to serve a
VBN system.
Action
Step Action
1 Using a PC web browser, browse to the IP address configured for the ETH 0
interface, and login to the YWS.
2 From the YesWare main menu, select the InterProxy module and select the
Configure InterProxy
function.
The "InterProxy Configuration Page" is displayed as shown in Figure 4-2 on
page 4-5.
3 Enter the InterProxy form entry items as described in Table 4-1 on page 4-6
according to your system requirements. Be sure to set InterProxy service
radial button to "on".
4 Record the values entered on the "InterProxy Configuration Page" according
to local office procedures. These values may be needed for some of the
provisioning tasks performed later.
5 Click Submit to save the InterProxy settings.
Note: Once you have configured the InterProxy, you should backup your
configuration on diskette and store the backup in a safe place. (See “Backing
up the InterProxy configuration” on page 13-27.)
6 Continue with the provisioning process by configuring the YWS as the VBN
gateway and Network Services System switch (see Chapter 5).
STOP
You have completed this task.
CAUTION - This step overwrites previous InterProxy values
All prior InterProxy configuration values will be overwritten. If you want to
discard the settings, click a module on the main menu (without clicking the
submit button) and the InterProxy settings will not
be submitted.