User`s guide

4-4 InterProxy VBN configuration
Software Release 2.30 YesWare Applications User’s Guide 08-01016-01
InterProxy configuration procedure
The system administrator must configure the InterProxy ETH 1 interface for
VBN routing. This is done using the InterProxy Configuration Page
launched using the Configure InterProxy function.
Procedure 4-1 on page 4-9 contains the steps required to configure the
InterProxy/ETH 1 interface to serve a VBN system..
InterProxy Configuration Page
Figure 4-2 on page 4-5 shows an example of the "InterProxy Configuration
Page." Table 4-1 on page 4-6 lists the settings and describes the information
required to complete form for the InterProxy system configuration.
CAUTION - Potential network outage
The InterProxy attempts to serve as the gateway for any network to which it is
connected. If the InterProxy ETH 1 port is accidentally connected to the host
network instead of the visitor network, the InterProxy will conflict with the host
network routers and likely cause a network outage.
Recommended InterProxy / ETH 1 configuration settings
Elastic Networks’ guidelines for configuring settings for the ETH 1 IP address,
network mask
, and DHCP range described in Table 4-1 on page 4-6.
These guidelines can help ensure that ample addresses are available and that
addresses do not conflict, especially when the system is installed in a corporate
Intranet.
These guidelines are intended only as suggestions. Your system administrator
may develop an addressing scheme that better fits your particular system
management configuration.