User`s guide

YesWare Server host network configuration 3-9
Software Release 2.30 YesWare Applications User’s Guide 08-01016-01
Procedure 3-1
Configuring the YWS host network interface
This procedure explains how to configure the YWS host network interface
(ETH 0) using the EON interface.
Requirements
To perform this procedure, you need the following:
• valid TCP/IP configuration for the YWS ETH 0 network interface,
including the following:
— IP address
— network mask (subnet) address
— network gateway address
• host name for the YWS
• DNS nameserver IP address (if applicable)
• time zone information for the YWS host network
Action
Step Action
1 Connect to the YesWare console using one of the methods described in
“YesWare Server console connection methods” on page 3-4.
2 Connect the YWS power plug to an appropriate power source, and flip the
power switch ON.
After the YWS completes its power-on initialization sequence, the YesWare
login prompt should appear as follows:
3 Enter the YWS login name and password.
—continued—