User`s guide

YesWare Server host network configuration 3-5
Software Release 2.30 YesWare Applications User’s Guide 08-01016-01
YWS PC/VT-100 connection
Figure 3-4 shows the method for connecting a PC with a VT-100 terminal
emulator or a VT-100 terminal to the YWS serial port (COM 2).
Figure 3-4
YWS PC or VT-100 terminal console connection
YWS telnet connection
For the initial configuration of the YWS, you can telnet to the EON interface
by connecting directly to the ETH 0 interface using a Category 5 cross-over
cable. You can also telnet to the EON over an existing network connection to
the ETH 0 interface to change EON settings. Figure 3-5 on page 3-6 shows the
methods for connecting to the EON interface over telnet.
CAUTION - Possible network conflict
The YWS ETH 0 interface has a default TCP/IP address configuration which could
conflict with the host network. DO NOT connect the ETH 0 interface to a host
network until you have re-configured the ETH 0 interface with a TCP/IP
configuration that is valid for the host network.