User`s guide

Introducing Visitor-Based Networking and YesWare 1-27
Software Release 2.30 YesWare Applications User’s Guide 08-01016-01
Installing a YesWare VBN system
The process of installing a YesWare VBN system, in broad terms, includes the
following:
5 Install the TCP/IP Ethernet local host LAN/WAN network to support the
YesWare Server connection (if none existing).
6 Install the YesWare VBN infrastructure (EtherLoop or Ethernet).
7 Configure the YWS on an existing local host LAN/WAN.
8 Provision the VBN infrastructure to support YesWare services.
9 Provision site-specific service billing requirements
10 Customize the host site and provision visitor services
This manual covers steps 7 through 10 of the YesWare system installation
process.
Organization of this manual
This document provides procedures for setting up the YesWare Server on the
local host network and for provisioning the YesWare system, as well as for
conducting on-going YesWare system operations and maintenance. In general,
the information is presented in the order in which you will need to use it. The
first part of this manual contains the instructions for using the YesWare
operating system and modules, and for the initial setup of the YesWare system.
The middle part of the document contains the procedures for provisioning site-
specific settings and billing information. The later chapters of the document
cover the YesWare system operations, administration and maintenance tasks.