User`s guide

YesWare security and administration 13-7
Software Release 2.30 YesWare Applications User’s Guide 08-01016-01
Procedure 13-2 (continued)
Restricting Remote Access
Step Action
3 Click View Subnet List and then click Submit Query.
The Remote Management Subnets screen appears as shown below.
Figure 13-5
Remote Management Subnets screen
This screen displays the current list of valid subnets. In the example above,
the entry 0.0.0.0/0 is all-inclusive, which means that all addresses are
allowed access to the YWS.
4 Click the Back button on the toolbar to return to the previous screen.
5 To add a subnet to the subnet list, click Add to Subnet List.
6 Enter the First IP Address in Subnet.
7 Enter the number Subnet Mask Bits (0-32). This value, together with the IP
address you entered in the step 6 defines the subnet. The higher the number
you enter, the fewer hosts will be allowed. For example, if you enter 32, only
the IP address you specified in step 6 will be allowed (all 32 bits must match).
If you enter 24, only the 255 host addresses that match the first 24 bits will be
allowed.
8 Click Subnet Query.
The Remote Management Subnets screen appears. The subnet values you
just entered are included in the list.
9 Repeat steps 6 through 8 to add as many subnets as required.
10 Delete any unwanted entries from the list (such as the all-inclusive 0.0.0.0/0)
by selecting the Delete from Subnet List option and then specifying the
First IP Address and Subnet Mask Bits for the subnet you want to delete.
11 When the subnet list is complete, restart the YWS so the changes will take
effect. See “Restarting the YesWare Server” on page 13-29 for complete
instructions.
STOP
You have completed this task.