User`s guide

9-10 YesWare PMS integration
Software Release 2.30 YesWare Applications User’s Guide 08-01016-01
tocFieldLetter A Enter the alphanumeric designator used to indicate the type of call to the
PMS in the outgoing call record. The YWS only uses this field if
outputType setting is >=3 (see outputType field description).
Note: For Promus/System 21 systems, use the default value of A. Hitachi
Standard and HOBIS Merge systems ignore this field.
baud 9600 Enter baud rate used for COM port communications. Acceptable baud rate
values include: 1200|2400|9600|38400
tocFieldPos 54 Enter the alphanumeric designator used to indicate the position in the
outgoing call record where the type of call
designator will appear. The
YWS only uses this field if outputType setting is >=3 (see outputType
field description).
Note: For Promus/System 21 systems, use the default value of 54.
Hitachi Standard and HOBIS Merge systems ignore this field.
staNumJust right Enter the desired justification setting for the station number in the call
record. The YWS only uses this field if outputType setting is >=3 (see field
description). YesWare always blank fills the record as necessary, and
never zero fills. Acceptable entries include the following:
•left
= left justified
• right
= right justified
Note: For Promus/System 21 systems, use the default value of right
.
Hitachi Standard and HOBIS Merge systems ignore this field.
threshold1 70 Enter the lower threshold in the FIFO record buffer. When this threshold is
crossed, an SNMP trap message is sent to the trap recipient location
which is configured in this field. The default setting of 70 means that the
YWS waits until 70 records are in the FIFO buffer before sending the
SNMP trap. See “SNMP notification of PMS link disruption” on page 9-16
for more information on how to configure this field.
threshold2 99 Enter the upper threshold of the FIFO record buffer. When this threshold
is crossed, records are sent to a service log instead of the PMS and
another SNMP trap message is sent to the trap recipient location which is
configured in this field. The default setting of 99 means that the YWS waits
until 99 records are in the FIFO buffer before sending records to the
service log and sending the SNMP trap. Records sent to the service log
must be manually posted to the billing system after the PMS link is re-
established. See “SNMP notification of PMS link disruption” on page 9-16
for more information.
—END OF TABLE—
Table 9-1 (continued)
HOBIC AckNak configuration settings
HOBIC AckNak
setting
Default
Value
Specifications and Entry Requirements