User`s guide

6-24 EtherLoop system provisioning
Software Release 2.30 YesWare Applications User’s Guide 08-01016-01
Procedure 6-4 (continued)
Provisioning EtherLoop modem management with a non-resident YWS
Step Action
9 Provision each CO and CPE modem with a valid TCP/IP address
configuration for the LAN on which the EtherLoop modems reside. The
modem TCP/IP configuration consists of the folowing:
• IP address
• subnet mask
• network gateway address
These settings are provisioned using the Port Manager / EtherLoop Modem
Provisioning / Add/Search [CO/CPE] Modem
functions, and must be
provisioned for every modem in the system (see Chapter 6).
10 Provision the modem port database according to your system requirements
using the rest of the Port Manager / EtherLoop Modem Provisioning
section (see Chapter 6).
11 Connect a PC to a network that can reach the host network. Test the
EtherLoop-OAM&P system configuration by browsing to the ETH 0 IP
address and attempting to use the YesWare OAM&P functions such as
EtherCraft and SNMP (see Chapters A and 14).
12 Remove the YWS from the EtherLoop host network. Configure the YWS on
the LAN where it will reside permanently. Test the EtherLoop-OAM&P system
configuration again by browsing to the ETH 0 IP address and attempting to
use the YesWare EtherLoop-OAM&P functions such as EtherCraft and
SNMP (see Chapters A and 14).
STOP
You have completed this task.