User`s guide

EtherLoop system provisioning 6-23
Software Release 2.30 YesWare Applications User’s Guide 08-01016-01
Procedure 6-4
Provisioning EtherLoop modem management with a
non-resident YWS
The following procedure lists the steps to create and provision an EtherLoop
modem management system with the YWS as a permanent resident on a
different LAN segment from the EtherLoop modems.
This procedure should be done after the EtherLoop client modems have been
installed on the host network.
Action
Step Action
1 Install the EtherLoop modems on the host network. See Elastic Networks
product documentation for instructions.
2 Install and connect the ETH 0 interface of the YWS to the same LAN segment
as the EtherLoop modems.
3 Configure the YWS on the LAN with a valid IP address configuration using
the procedure(s) described in Chapter 3 of this document.
4 Using a PC web browser, browse to the IP address configured for the ETH 0
interface, and login to the YWS.
5 Select the NSS Maintenance / System Maintenance / Set Modex Daemon
info function. Set the Modex Daemon to ETH 0.
6 In the Modex Daemon module, stop and re-start the Modex Daemon. This
step can also be done by shutting down and re-booting the YWS.
7 Connect the YWS ETH 0 interface to same LAN segment as the EtherLoop
client modems on the host network.
8 Select the Port Manager / EtherLoop Modem Provisioning / Find New
Modems function. Autodetect the modems connected to the ETH 0 network
interface to create the modem database.
—continued—