User`s guide

6-18 EtherLoop system provisioning
Software Release 2.30 YesWare Applications User’s Guide 08-01016-01
Procedure 6-2 (continued)
Provisioning Modem Connection Billing
—continued—
Table 6-4
CPE modem provisioning parameters
CPE Modem Configuration
Parameters
Parameter/Entry description
CPE MAC Address
(REQUIRED)
Enter the MAC address of the CPE modem (may be automatically
discovered using the Find New Modems
function or entered manually in
this field). MAC addresses manually entered in this field without colons
will be rejected. See “EtherLoop modem MAC addressing conventions”
on page 6-25.
CO MAC Address
(REQUIRED)
Select the MAC address of the CO modem assigned to this CPE modem.
The CO MAC Address is provisioned in the Co Modem Configuration
dialog and selected from a pull-down list in this dialog. If this entry is
unknown, use the "Client Addresses" function in EtherCraft to determine
the modem pair assignments.
Modem Identifier Not used
Class String Not used
Location
(REQUIRED)
Text field entry indicating the location assigned to the CPE modem.
Location should be assigned according to local office procedures.
IP Address Not used
Subnet Mask Not used
Gateway Address Not used
IP Enabled Not used
Link Status Not used
Broadcast Storm Threshold Not used
Number of Address Filters Not used
Firmware Version Not used
FPGA Modem Version Not used
FPGA BTEQ Version Not used
Port
(REQUIRED)
CO modem port assigned to the CPE modem. For ELMo 8 CO modems,
the port is always "0". For ELMo 120 CO modems, the port assigned can
be 0-11. If the port is unknown, use "Client Addresses" in EtherCraft.
Port Use Context
(REQUIRED)
Select the guest
Port Use Context from pull-down menu. This is the only
Port Use Context available using Modem Connection Billing.