User`s guide

6-6 EtherLoop system provisioning
Software Release 2.30 YesWare Applications User’s Guide 08-01016-01
Procedure 6-1 (continued)
Provisioning Enhanced Modem Billing
—continued—
Table 6-1
CO modem provisioning parameters
CO Modem
Configuration
Parameters
Parameter description
CO MAC Address
(REQUIRED)
MAC address of the CO modem automatically generated by Find New Modems
function, or manually entered here.
Note: MAC addresses manually entered in this field without colons will be
rejected. See “EtherLoop modem MAC addressing conventions” on page 6-25.
IP Address Not Used
Subnet Mask Not Used
Gateway Address Not Used
Modem Identifier Not used
Modem Class Not used
Location
(REQUIRED)
Text entry field used to indicate location of CO modem such as "120-1-1-1" for a
120 modem in rack-1/shelf-1/slot-1.
Broadcast Storm
Threshold
Not used
IP Enabled
(true/false/undef)
Not used
Link Status
(true/false/undef)
Not Used
Firmware Version Not used in initial provisioning. However, system auto-fills this field if a firmware
upgrade is performed on the modem.
FPGA Modem
Version
Not Used
FPGA BTEQ
Version
Not Used
Hardware Revision Not Used
Modem Type
(REQUIRED)
Pull-down list used to select the type of CO modem (ELMo 120 or ELMo 8).
ModeX Daemon IP Not Used
Comments Text field used for descriptive information about the modem, location, facility, etc.