User`s guide

EtherLoop system provisioning 6-3
Software Release 2.30 YesWare Applications User’s Guide 08-01016-01
Procedure 6-1
Provisioning Enhanced Modem Billing
Use this procedure to configure the YWS to use Enhanced Modem Billing.
Action
Step Action
1 Select the Set ModeX daemon information function in the System
Maintenance section of the NSS Maintenance module. The "Configuration
parameters: modex" dialog appears as shown in Figure 6-11.
Figure 6-1
Configuration parameters: modex dialog
2 Set the Modex Daemon "ETHER_INTERFACE_NAME" value to ETH 1.
3 Select Port Manager from the YesWare Main Menu.
—continued—
Enhanced Modem Billing firmware requirement
Enhanced Modem Billing requires that all EtherLoop modems in the system use
Generation 2.09 (or higher) firmware. If the system contains EtherLoop modems
running the older Generation 1 firmware, they must first be upgraded to Gen 2.09
(or higher) before performing this procedure.
Using the Find New Modems function
To use the Find New Modems function described in this procedure, the EtherLoop
modems must reside on the same LAN segment as the YWS.