User`s guide

5-6 VBN gateway and Network Services System switch configuration
Software Release 2.30 YesWare Applications User’s Guide 08-01016-01
Procedure 5-1 (continued)
Provisioning the VBN gateway and Network Services System switch
—continued—
Table 5-1
Network Services System switch settings
Switch Setting Entry Description/Requirement
Switch type Select the "Network Services System " switch type
Switch IP Address Select the IP address of the ETH 1 interface provisioned previously in the Add
Switch Address dialog.
Gateway Address Select the Gateway address provisioned previously using the Add Gateway
Address function. This address should be the same address as the IP address of
the ETH 1 interface as provisioned in the InterProxy Configuration Page.
Subnet Mask Select the Subnet Mask address provisioned previously using the Add Subnet
Mask function. This address should be the same address as the Network Mask of
the ETH 1 interface as provisioned in the InterProxy Configuration Page.
Location Text entry field indicating the physical location of the Network Services System
switch (YWS). Defined according to local office procedures.
Number of high
speed ports
0/1/2 - Select "0." The Network Services System does not have a "high-speed"
port.
Parent switch IP
address
Select "None." The Network Services System does not have a parent switch. See
Chapter 7, “Provisioning the Ethernet-VBN switches and ports” for more
information.
Parent switch port Leave this field blank. The Network Services System does not have a parent
switch. See Chapter 7, “Provisioning the Ethernet-VBN switches and ports” for
more information.
Enabled true/false/undef - Select "true" to enable the Network Services System switch.