User guide

3-16 BitStorm Server host network configuration
Software Release 3.00 StormTracker-Site Manager and Administration User Guide 08-01148-01-200
Procedure 3-3
Setting the DNS nameserver(s) for the BitStorm
Server
Use this procedure to identify the DNS nameserver used by the BitStorm
Server. The StormTracker Configuration Manager nameserver
command can
be used to display, add or delete the IP address(es) of the DNS nameserver(s)
supporting the BitStorm Server. Nameserver addresses can be added to the
beginning or the end of the nameserver list. This procedure describes each of
these command capabilities.
Requirements
To perform this procedure, you need the following:
• a connection to the BitStorm Server ETH 0 network interface using one of
the methods described in “BitStorm Server console connection methods”
on page 3-4. host name for the BitStorm Server
• a valid DNS nameserver IP address
Action
Step Action
1 Login to the BitStorm Server (the steps for logging into the BitStorm Server
are presented in Procedure 3-1 on page 3-10).
2 To di sp la y
the existing nameserver addresses, type nameserver at the
command prompt (OSM#>), and press <ENTER>. The system should
appear similar to the following:
—continued—
Valid host and domain name required
The BitStorm Server must also have a valid DNS host/domain name
(host.domain.domain) defined using the StormTracker Configuration Manager
configure
command. See Procedure 3-1 on page 3-10.