User guide

3-10 BitStorm Server host network configuration
Software Release 3.00 StormTracker-Site Manager and Administration User Guide 08-01148-01-200
Procedure 3-1
Configuring the BitStorm Server host network
interface
This procedure explains how to configure the BitStorm Server host network
interface (ETH 0) using the StormTracker Configuration Manager.
Requirements
To perform this procedure, you need the following:
• valid TCP/IP configuration for the BitStorm Server ETH 0 network
interface, including the following:
— IP address
— network mask (subnet) address
— network gateway address
• host name for the BitStorm Server
• DNS nameserver IP address
• time zone information for the BitStorm Server host network
Action
Step Action
1 Connect to the YesWare console using one of the methods described in
“BitStorm Server console connection methods” on page 3-4.
2 Connect the BitStorm Server power plug to an appropriate power source, and
flip the power switch ON.
After the BitStorm Server completes its power-on initialization sequence, the
YesWare login prompt should appear as follows:
3 Enter the BitStorm Server login name and password.
—continued—