User guide

BitStorm Server host network configuration 3-9
Software Release 3.00 StormTracker-Site Manager and Administration User Guide 08-01148-01-200
StormTracker Configuration Manager commands
Table 3-3 lists the StormTracker Configuration Manager commands used to
configure the BitStorm Server.
Table 3-3
StormTracker Configuration Manager commands
Command Function Syntax
help Displays this list of commands. help
route Display BitStorm Server routing table. route
port Display BitStorm Server ETH 0 and ETH 1 port
settings.
port
ping Test basic communications between the BitStorm
Server, client computers, and the host network.
ping [IP address or DNS name]
passwd Change admin
user password. For security
purposes, use this command to change the default
password after the first login.
passwd
configure Configure the ETH 0 interface network IP address,
gateway, BitStorm Server host name (see
nameserver
command below), and time zone.
configure
See Procedure 3-1 on page 3-10.
nameserver
(optional)
Specify the IP address of the nameserver the
BitStorm Server will use.
nameserver
(displays current nameserver
settings)
nameserver [front/last/del]
(adds or deletes nameservers)
date Display and set system date and time date
reboot Shut down and re-start the BitStorm Server. Always
use this command or the Web interface to re-boot
the BitStorm Server. Never
use only the power
switch for a re-boot, as an uncontrolled
shutdown/re-start could corrupt the StormTracker
Configuration Manager software.
reboot
shutdown Shut down the BitStorm Server. Always
use this
command or the Web interface to shut down the
BitStorm Server. Never
use only the BitStorm
Server power switch for a shutdown.
shutdown
exit Close the StormTracker Configuration Manager
and exit to the login prompt. To prevent
unauthorized access to the BitStorm Server,
always use this command after configuration tasks
are done.
exit
timezone Change the time zone used by the BitStorm Server. timezone