Specifications

2-30
ELMo 120 Multiplexer installation and testin
g
Revision 2.01 ELMo 120 Multiplexer Installation and Maintenance Guide 08-01023-01
EtherLoop end-to-end testing (continued)
Action
Step Action
1
Identify the modem pair bein
g
tested.
2
Switch the power switch on the ELMo 120 Multiplexer Power card to the ON
position.
3
Verify dial tone on the room phone.
4
If the laptop is runnin
g
, shut it down.
5
Connect the Ethernet PC card RJ-45 adapter cable to the Ethernet PC card.
6
Connect one RJ-45 plu
g
of the Ethernet cable to the PC card
RJ-45 adapter, and the other end to the "To PC" RJ-45 port on the Elite
modem.
7
Start the laptop, and launch the browser application.
8
In the browser application, enter the IP address of a known, workin
g
site on
your network or on the Internet. Repeat this step for several sites.
9
Once data connectivity has been established in step 8, verify dial tone a
g
ain
on the room phone.
10
If the voice or data connectivity fails, see Chapter 3, “ELMo 120 Multiplexer
maintenance.”
STOP
You have completed this task.