Specifications

Elastic Networks 2 BitStorm 1900 Installation and Testing
08-01101-01, Rev. 1.50 BitStorm 1900™ Installation and Maintenance Guide 2-77
Step Procedure cont.
6.) Verify that the green LED at the EtherLoop hub/router port illumi-
nates, indicating connectivity is established from the BitStorm 1900
shelf to the hub/router.
NOTE: If a 10/100 Base-T port on the BitStorm 1900 Switch Card is connected
to a 10Base-T network, that port LED should display a yellow-orange
light. If a 10/100Base-T port on the BitStorm 1900™ Access Multiplexer
card is connected to a 100Base-T network, that port LED should display
a green light.
7.) Proceed according to the following table:
STOP
If the application is Then
Data-only
GO TO:
"Task 011: Installing the Data-only
Connections, on page 89."
Voice/data
GO TO:
"Task 009: Installing Voice/Data &
Filter Shelf Connections, on page
78."
OR
"Task 010: Installing Voice/Data w/
Filter 66-Block Connections, on page
85."