Specifications

2 BitStorm 1900 Installation and Testing Elastic Networks
2-68 BitStorm 1900™ Installation and Maintenance Guide 08-01101-01, Rev. 1.50
Step Procedure cont.
NOTE: The redundant power supply sources connect to two pairs of wires on
the BitStorm 1900’s power harness and are electrically the same.
5.) Route the other end of the DC power harness to the DC power
connector on the backplane of the BitStorm 1900 modem shelf.
The connector only fits one way.
6.) For an AC power supply, connect the power cord to the IEC termi-
nal connection on the front panel.
Figure 2-9: Typical Power Connection to 70W/260W Power Source
7.) Route the other end of the cord to a grounded socket.
8.) Re-seat the power, modem, and MIU Shelf processor/Switch cards
into their shelf backplane connectors.
FUSE
( 70W: 4 AMP, 250V
260W: 10 AMP, 125V AC or
5 AMP, 250V AC)
ON/OFF