Specifications

Appendix C: SNMP MIBs Elastic Networks
C-186 BitStorm 1900™ Installation and Maintenance Guide 08-01101-01, Rev. 1.50
CPEMdmFirmwareRev The firmware revision for this
CPE modem interface
Read-only This would be obtained from
the extent Capabilities (Gen-
eralOp).
This would be obtained only at
initialization time and saved in
the memory.
CPEMdmCurModulation The modulation scheme cur-
rently in use on this interface
Read-only This would be obtained from
the extent Capabilities (Gen-
eralOp).
This would be however
obtained only at initialization
time and saved in the mem-
ory.
CPEMdmSpeedCount The number of speeds sup-
ported by CPE modem inter-
face.This is also the number of
entries in the enEloopCPEMdm-
SpeedTable
Read-only This would be obtained from
the extent GetModemInfo
(GeneralOp).
This would be however
obtained only at initialization
time and saved in the mem-
ory.
CPEMdmModemRev The modem hardware revision
number
read-only This would be obtained from
the extent Capabilities (Gen-
eralOp).
This would be obtained only at
initialization time and saved in
the memory.
CPEMdmModemBTE-
QRev
The modem hardware BTEQ
revision number
read-only This would be obtained from
the extent Capabilities (Gen-
eralOp).
This would be obtained only at
initialization time and saved in
the memory.
CPEMdmReset If reset(2) is written to this
object, this modem is re-booted.
A read of this variable, if it exists,
always return normal(1).
Read-write Setting this value to reset (2)
will cause the extent Reset-
Modem (GeneralOp) to be
sent.
CPEMdmClearStats If clear(2) is written to this object,
the counters on this interface
and the associated Ethernet port
are set to 0 and a ??? trap is
sent. Reading this object always
returns a value of normal(1)
Read-write Setting this value to clear (2)
will cause the extent ClearSta-
tistics (GeneralOp) to be sent.
The CPE Modem Interface Configuration Table
Variable Description Accessibility Implementation