Specifications

Appendix C: SNMP MIBs Elastic Networks
C-164 BitStorm 1900™ Installation and Maintenance Guide 08-01101-01, Rev. 1.50
Table C-3: BS1900 Shelf Interface Group
Table C-4: CO Modem Interface Group
Feature SNMP Input Variable Description
Enabling Video Protect Mode on
entire Shelf
ShelfVideoProtectMode Setting this value to one (1) will turn video protect
mode “on” for all EtherLoops on the shelf.
Enabling Traps to be forwarded
to the Shelf
EnableShelfTraps Setting this value to one (1) will enable all traps to
be forwarded to the shelf.
Enabling Traps to be forwarded
to the CO modem
EnableShelfTraps Setting this value to one (1) will enable traps to
be forwarded to the CO modem.
Enabling Traps to be forwarded
to the CPE modem
EnableShelfTraps Setting this value to one (1) will enable all traps to
be forwarded to the CPE modem.
Feature SNMP Input Variable Description
Setting the maximum number of
broadcast messages.
COMdmIfMaxBroadcast Setting this object defines the maximum number
of broadcast messages per second that can be
sent out the associated Ethernet port and all inter-
faces associated with this Ethernet Port.
Disabling and Enabling broad-
cast traffic
COMdmIfBlockBroad-
cast
Setting this object to “enabled” will allow the
modem to forward all broadcast traffic out the
port.
Setting maximum upstream
throughput
COMdmIfMaxUpThruput
Setting maximum downstream
throughput
COMdmIfMaxDownThru-
put
Enabling and disabling Video
Protect mode – Setting the
upstream symbol rate
COMdmIfMaxUpSymbol-
Rate
Enabling and disabling Video
Protect mode – Setting the
downstream symbol rate
COMdmIfMaxDownSym-
bolRate
Setting the time in seconds after
HDLC frames should be
removed from the internal buff-
ers
COMdmIfHDL-
CiscThreshold
Setting the modem to always run
at the highest speed – setting
Forced mode
COMdmIfForceHigh-
Speed