Specifications

Elastic Networks 2 BitStorm 1900 Installation and Testing
08-01101-01, Rev. 1.50 BitStorm 1900™ Installation and Maintenance Guide 2-95
Task 013: Configuring the MIU
Complete the following steps to configure the MIU.
Step Procedure
1.) Ensure that the BitStorm 1900 Access Multiplexer is powered up.
2.) Verify the PC has an ASCII terminal emulator loaded (i.e., Hyper-
terminal software, etc.).
3.) Connect the PC to the MIU card using the MIU Craft Cable (RS-
232 to RJ-11 adapter and telephone cable) as shown in Figure 2-
23, "Craft Connection with the MIU Craft Cable," on page 96.
a.) Connect the DB-9 end of the cable to the serial COM port on
the PC.
b.) Connect the RJ-11 connector to the RS-232 jack on the MIU
card.