Installation guide

1-14 Installing the StormPort 405 Modem
Revision 1.00 StormPort 405 Modem Installation Guide 08-01141-01
Task:
Installing the StormPort 405
Note: Some PCs and laptops require an adapter between the RJ-45
Ethernet cable and the Ethernet connector on the PC/laptop (the
adapter is often a round, 8-pin connector).
Step Action
1 Make sure all of the StormPort 405 equipment is available before
proceeding.
2 The StormPort 405 is connected with an RJ-11 modular phone line
cord to the telephone wall jack. Insert one end of the RJ-11 cord into
the telephone wall jack and insert the other end into the jack in the rear
of the StormPort 405, as shown below:
3 Slide the phone set onto the StormPort 405, as shown below:
4 Connect the StormPort 405 to the phone set with the second RJ-11
connector attached to the phone.
5 The StormPort 405 is connected to the computer with an RJ-45
Ethernet cable (RJ-45 Ethernet cable is not included). Insert one end of
the RJ-45 cable into the 10Base-T Ethernet card connector on the
computer, and the other end into the Ethernet port on the side of the
StormPort 405.