User manual

Flashing Memories
Any of the programmed scene memories
can be flashed to the level of the GRAND
MASTER.
1. Select the required memory page
using the MEMORY PAGE button
2. Press and hold down the CHANNEL
FLASH button corresponding to the
memory to be flashed. The
corresponding memory will be output.
3. Release the CHANNEL FLASH
button. The corresponding memory
output will return to the level set by
the PRESET fader.
Outputting a Sequence
Any one of the three sequences can be
output (assuming it has been
programmed). The output from the
sequence is added to that from any scene
memories currently being output.
1. Press one of the SEQUENCE buttons
to transfer it to the outputs. The light
in the button comes on indicating the
sequence is active. The DISPLAY
shows the current step number being
output. The sequence starts at step 1.
2. Use the SEQUENCE MASTER to
control the output level of the
sequence. The speed, direction, and
transition between steps can be
adjusted as required (see the
following sections for details).
3. Press the SEQUENCE button again
to remove the sequence from the
outputs. The light in the button goes
out indicating the sequence is not
active. The DISPLAY goes blank.
Page 34 ELARA 7371000 25.9.98
Run Mode