User`s guide

ELAN HOME SYSTEMS
USER'S GUIDE
Page 12 ©2006 ELAN Home Systems All rights reserved.
II
Operation
Switching On and Off
Off Mode
Off mode should be used only if the VIA!dj is not being used for an extended period of
time. There is a short wait while the unit is switched to Off mode; switching the unit On
from Off mode may take a few minutes. You can safely disconnect the power cord from
the VIA!dj in this mode.
Important Note: When moving the unit for any reason, make sure that it is powered Off
and that suffi cient time elapses for the Hard Disk Drive to stop spinning (aproximately
one minute).
To enter Off mode:
• To switch Off, press the STANDBY button on the front panel of the VIA!dj.
Next, press the action button labelled Yes below the LCD display.
The front panel display shows:
• Next, press the action button labelled Yes below the LCD display.
After a brief period, the unit will switch Off and the Standby LED will glow red.
To turn the VIA!dj back On:
• To switch the unit back On, press the STANDBY button on the front panel of
the VIA!dj or on the remote control. The unit will switch on and begin the boot
up process, the Standby LED will glow green and the VIA! Touch Panel will
display the Main Menu screen.
The boot up process will take approximately two minutes.
Switch Off
This Unit?
No Yes