Specifications

control
15
©2004 ELAN HOME SYSTEMS • Lexington, KY USA • All Rights Reserved.
MULTI-ROOM CONTROLLERS
FEATURES & SPECS
Fixed and variable zone outputs
with ELAN page and door chime
audio on both
2 Sense Inputs can automatically
turn zone ON or OFF and trigger
2 on-board relays
SPECIFICATIONS:
Gain: ..........................0dB at max. volume
Frequency Response: 20 - 20kHz, +/- 0.5dB
THD + Noise: ..................................<0.015%
Stereo Cross Talk: ................................-70dB
Bass Boost/Cut: ................+/-12dB @ 100Hz
Treble Boost/Cut: ..............+/-12dB @ 10kHz
Fixed outputs can be configured for: ..........
Music only, music + page + doorbell,
mono or stereo
HDC2010 DUAL ZONE OUTPUT CARD
The Dual Zone Output Card provides high-
quality audio signal processing for two
zones. Each zone can independently select
a source, control volume, bass, treble, and
route IR, page and doorbell signals. RJ-45
jacks provide a quick connection for
keypads or a PHD12 Precision Panel.
Note: The HDC2010 requires MCU Firmware
Rev. 3990 or higher and cannot coexist in
the same MCU with older Dual Zone
Output Cards (HDC1010).
FEATURES & SPECS
Four source inputs
Buffered loop outputs
+/- 3dB source leveling
SPECIFICATIONS:
Gain:..........................................0dB Nominal
Frequency Response:....20 - 20kHz, +/- 0.5dB
THD + Noise: ..................................<0.005%
Stereo Cross Talk: ................................-85dB
Buffered Loop Outputs: ......0dB, fixed gain
HDC1020 QUAD SOURCE INPUT CARD
Each Quad Source Input Card accepts line-
level connections of up to four stereo
sources located within 20 feet of the MCU.
Input leveling jumpers (+/-3dB) balance
each source in the system. Buffered loop
outputs allow you to share system sources
with a home theater or media room.
Use the HDC1020 with an IRAVWP and
locate any source up to 300 feet away
from the MCU!
HDC2042 AUTOMATION CONTROL CARD
This essential card is the RS-232 link for an
HD system. Not only is it required for all HD
system programming, it is also the link
between the homeowner’s PC and the HD
system, allowing VIA!
®
PC System Control
Software to be used for system control.
SEE SOFTWARE SECTION,
Page 87.
HAS2
The HDC2042 and
VIA!
®
PC software
are sold as part of
the HAS2 Home
Automation Suite.
CO_FINAL.qxd 1/24/05 3:20 PM Page 15