Specifications

complete
96
©2006 ELAN HOME SYSTEMS • Lexington, KY USA • All Rights Reserved.
ACCESSORIES
The PVSE Precision Panel makes it easy to
connect up to six VSE Electronic Volume
Controls to any ELAN system, and it’s also
the perfect trim-out solution for VSEs in
any stand-alone system.
The PVSE is one of ELAN’s new “half-
frame” Precision Panels. Two half-frame
panels can be mounted in one standard-
size Precision Panel frame, giving the
flexibility to mix and match the Precision
Panels needed to complete a neat,
problem-free trim-out.
The back of the PVSE features six clearly
labeled 110 punch-down blocks that
provide independent connections for
override, IR and sense; plus two additional
punch-down connectors for easy routing
of VSE IR signals to the System12 Precision
Panel (PS12). Two RJ-45 jacks on the
rear of the panel make it easy to route
override signals from the PZ600
Communication Controller Precision Panel,
and to link multiple PVSE panels together.
There’s also a bank of six dip switches that
allow turning the front-panel VSE-specific
IR Out ports into “ALL” ports. In stand-
alone applications, this allows all six VSEs
to control any or all sources.
The PVSE’s front panel was designed with
stand-alone applications in mind. Six
+12VDC trigger inputs, plus a trigger
“ALL” port, allow muting any or all VSEs
whenever voltage is not present. Six IR
inputs, plus an “ALL” port, allow an SR1
Sense/Relay/IR Controller to independently
control VSEs connected to the panel.
Six IR OUT ports, plus an IR OUT “ALL”
port, allow each or all VSEs to control
source components in a stand-alone
system.
The VSEs are powered by an ELAN PWR12
+12VDC, 2A Power Supply (included).
PVSE VSE ELECTRONIC VOLUME CONTROL PRECISION PANEL
The PV12 Video Precision Panel provides
a clean and easy way to connect up to 12
runs of coaxial cable for composite and
component video to the System12 A/V
Controller or Z•880 Video Controller.
Twelve gold-plated F-to-RCA barrel
connectors are mounted on flanges
angled at 45 degrees. The angled flanges
ensure that all coax runs slide easily back
into the wall after termination, and
that the cables are not bent past their
specified limits, which can cause damage
resulting in signal loss.
The PV12 is one of ELAN’s new “half-
frame” Precision Panels. Two half-frame
panels can be mounted in one PF2
Precision Panel Frame, giving the installer
the flexibility to mix and match all the
Precision Panels needed to complete a
neat, problem-free trim-out. Two PV12s can
be mounted in one frame to accommodate
24 video outputs.
PV12 VIDEO PRECISION PANEL
FEATURES
1/2-frame Video Precision Panel
12 F-to-RCA connectors
Angled flanges for easy & safe coax
wire management
Perfect for use w/S12 A/V Controller
& Z•880 Video Controller
Fits in PF2 Precision Panel Frame
(required for installation), see pg. 101
FEATURES
1/2-frame Precision Panel for 6 VSE
Electronic Volume Controls
Easy to interface w/PS12 & PZ600
Precision Panels
Multiple PVSEs can be linked
together
110 punch-down connectors w/clearly
labeled silkscreen for error-free
terminations
Front panel trigger, IR IN/OUT jacks
for stand-alone applications
PWR12 12V, 2A power supply incl.
Fits in PF2 Precision Panel Frame
(required for installation), see pg. 101
ORDER NO. PVSE
ORDER NO. PV12