Installation manual

ELAN HOME SYSTEMS INSTALLATION MANUAL THP525W/THP650W/THP650D

Mounting Rough-In Brackets (cont’d)

4. Once the drywall has been installed, carefully and accurately

cut out the speaker holes using a routing tool or similar device.

A drywall professional may perform this step.

After the drywall is up and the the holes are cut, the speaker frame

and speaker grille may be removed for painting (see Painting for

more details). It is also possible to install only the speaker frame and

speaker grille. Remove the speaker bafﬂ e until the jobsite is secure

then replace it when the ﬁ nal installation is taking place.

Mounting Speakers in Rough-In Brackets

1. Remove speaker grille and set speaker face down.

2. Locate the speaker wire and pull through the wall opening.

3. Connect the speaker wire. Be sure to observe correct polarity!

4. Insert the speaker into the the wall opening and carefully tighten

each clamping screw, alternating diagonally between each screw

position to ensure proper ﬁ t.

5. Once the speaker is mounted in the wall, point the tweeter.

See Pointing Speakers for details.

7. Set the EQ and Bass switches (EQ and Phase switches for

THP650D). See Setting Switches for details.

8. Replace the speaker grille.