Installation manual

E L A N H O M E S Y S T E M S
Page 22 © ELAN Home Systems 2009 • All rights reserved.
V85 INSTALLATION MANUAL
SYMPTOM
CAUSE
SOLUTION
No source or zone selected
from RS-232 controller.
1. RS-232 controller incorrectly
programmed.
Verify/correct programming.
Verify RS-232 wiring. Check wire
integrity and pin-out configuration.
RS-232 Control
2. RS-232 signal path wiring bad.
Incorrect source and/or zone
selected.
The V85 RS-232 commands
were incorrectly programmed.
Verify/correct programming.
3. UNIT ID DIP switches incorrect.
Verify/correct DIP switches.
4. BAUD RATE switches incorrect.
Verify/correct DIP switches.
Acknowledgement
&V85,ACK,xxx<CR> is not
received within 200ms
1. The command was formatted
incorrectly.
Verify/correct programming.
2. An error has occurred in the
V85.
Turn unit OFF, then back ON.
3. Serial cable not connected
or defective.
Connect or replace serial cable.
4. V85 does not have power.
Connect power, check breakers.
SYMPTOM
CAUSE
SOLUTION
Video does not appear on desired
TV/monitor. Front of V85 displays
correct source/zone.
1. V85 output cables incorrectly
routed. TV/monitor connected
to incorrect output.
V
ideo Switching
Incorrect source displays on
TV/monitor. Front of V5 displays
correct source/zone.
Incorrect programming.
Verify/correct IR programming.
Verify/correct video wiring.
2. TV/monitor has incorrect input
selected.
Select correct video input on
TV/monitor.
3. Video wiring bad/damaged.
4. Video source not sending video
(not connected, playing, or
turned on).
Verify/correct video source
problem.
Verify/correct video input wiring.
V85 input cables incorrectly
routed. Source connected to
incorrect V85 input.
Verify/correct video output wiring.
Incorrect source displays on
TV/monitor. Front of V85 displays
incorrect source/zone.
Component video sources display
correctly, composite source does
not display at all.
1. Composite video source not
connected to same type (Y, P
B, PR)
input as TV/monitor.
Ensure same type (Y, P
B, PR) input
& output used for all composite
video sources and TVs/monitors.
2. TV/monitor has incorrect input
selected.
Select correct composite video
input on TV/monitor.