Installation manual

E L A N H O M E S Y S T E M S
© ELAN Home Systems 2009 • All rights reserved. Page 21
V85 INSTALLATION MANUAL
6. Troubleshooting
SYMPTOM
CAUSE
SOLUTION
No power up.
1. No AC power.
Connect Power Cord to AC outlet.
Check AC circuit breaker.
2. Blown fuse.
Replace fuse with specified type.
General
SYMPTOM
CAUSE
SOLUTION
No source or zone selected
from IR controller (keypad,
hand-held remote, etc.).
IR LED does NOT flash
when button pressed.
1. IR controller not programmed.
Program IR controller.
Verify IR signal path wiring.
Check keypads, IR sensors, IR
distribution blocks, V85 IR Input
jack, IR emitters, etc.
IR Control
2. IR signal path wiring bad.
No source or zone selected
from IR controller (keypad,
hand-held remote, etc.).
IR LED DOES flash when
button pressed.
1. Incorrect IR commands
programmed (not V85
commands).
Verify/correct IR programming.
Intermittant or no source or
zone control from IR control-
ler (keypad, hand-held
remote, etc.). IR LED flickers
or is lit constantly.
IR flooding.
Check IR receivers for ambient
light or plasma TV flooding.
Incorrect source and/or zone
selected.
Incorrect V85 IR commands
programmed.
Verify/correct IR programming.
2. UNIT ID DIP switches incorrect.
Verify/correct DIP switches.