Specifications

©2011 ELAN HOME SYSTEMS • CARLSBAD, CA USA • ALL RIGHTS RESERVED
IR Systems
62
The IRIC is a 3.5 mm mono “mini”plug intercon-
nect cable that is used for IR connections between
ELAN multi-room controller IR output ports and
any source that has a 3.5 mm IR input jack. Also
perfect for routing the trigger outputs of ELAN
multi-room controllers to ELAN amplifiers, Z•Fans
and the Z•Power Controller.
FEATURES
 Plug-and-play cable for direct IR jack
connections between components
 3.5 mm plug-to-3.5 mm plug, 2 m length
 Available in pkgs. of 6
 Not for use with the IRD4 Amplified
Distribution Block
 Non-retail packaging
IRIC IR INTERCONNECT CABLE
Designed specifically to allow you to control one
source from two independent IR outputs, the
IRYC is a one foot long “Y” cable that converts
any ELAN IR Emitter into a dual-plug IR emit-
ter. Internal diodes built into the IRYC prevent
conflicts between IR outputs.
FEATURES
 1-foot “Y” cable for dual-plug / single-emitter
applications
 Internal diode protection
 Non-retail packaging
IR ACCESSORIES
Note: The IRIC IR Interconnect Cable can not be
used w/the IRD4 Amplified IR Distribution Block.
For connecting the IRD4 to any ELAN IR output,
use the 3.5 mm quad-to-mono interconnect cable
incl. with the IRD4.
ORDER NO. IRIC
IRYC IR EMITTER “Y” CABLE
ORDER NO. IRYC
PWR2 200mA, 12 VOLT DC
REGULATED POWER SUPPLY
For larger distributed IR systems, this regulated
2.1 amp power supply will handle up to ten IRD4s
and all the sensors and emitters connected to
them. Full-color retail box is standard.
PWR3 DC REGULATED
POWER SUPPLY
For use with the IRD4 Amplified IR Distribution
Block, this regulated 200mA power supply is
capable of powering the IRD4 and all the sensors
and emitters connected to it. Full-color retail box
is standard.
ORDER NO. PWR2
ORDER NO. PWR3
See pg 73 for Power Supply specifications