Specifications

ELAN HOME SYSTEMS COM2 Communications Controller

If your telephone equipment causes harm to the telephone network, the telephone company may discontinue your service

temporarily. If possible, they will notify you in advance. But, if advance notice isn’t practical, you will be notified as soon as

possible. You will be notified of your right to file a complaint with the FCC. Connection to party line service is subject to state

tariffs. Contact the state public utility commission, public service commission or corporation commission for information.

If your home has specially wired alarm equipment connected to the telephone line, ensure the installation of this [equipment

ID] does not disable your alarm equipment. If you have questions about what will disable alarm equipment, consult your tele-

phone company or a qualified installer. Your telephone company may make changes in its facilities, equipment, operations, or

procedures that could affect the proper functioning of your equipment. If they do, you will be notified in advance to give you an

opportunity to maintain uninterrupted telephone service. If you experience trouble with this telephone equipment, please con-

tact

ELAN TECHNICAL SUPPORT at 1-800-622-3526

for information on obtaining service or repairs. The telephone com-

pany may ask that you disconnect this equipment from the network until the problem has been corrected or until you are sure

the equipment is not malfunctioning.

If the telephone features are not functioning or are malfunctioning, switch off the COM2 Communications Controller (located on

the rear panel). This will directly connect the telephone line with all the telephones connected to the package. Contact your

dealer for repairs.

This equipment may not be used on coin service provided by the telephone company. Connection of party lines is subject to

state tariffs. (Contact your state public utility commission for information).

DISCLAIMER:

The ELAN COM2 Communications Controller is an advanced design capable of interfacing with most telecommunication

devices and central office switches. It has been thoroughly tested and should work satisfactorily with most telephone equip-

ment. However, ELAN in no way represents, guarantees, or claims that the ELAN COM2

Communications

Controller will

achieve 100% functionality with every manufacturer’s telephone equipment or with every central office feature.

ELAN Home Systems strongly recommends the use of a quality in-line Telephone Surge Suppressor such as the Z•POWER

Power Controller or TH31SRG surge Protection Hub. This device should be installed between the incoming telephone ser-

vice line and the COM2’s TELCO IN jack. If your installer has not installed such a device, please insist that they do so. For

additional protection on large wiring networks, surge suppression can also be added in series with the COM2’s PHONE OUT

jack, protecting your house network and COM2 from surge in both directions.

Although the installation of telephone line surge suppression is an important precautionary measure to take in protecting

your COM2 from surge-related damage, it does not completely eliminate the possibility of surges entering into the system

through the telco line due to near or direct lightning strikes. ELAN Home Systems does not warranty this, or any product

against surge-related damage; nor does this warning imply that, if surge protection is installed and the unit is subsequently

damaged by surge, ELAN Home Systems would repair or replace the unit under warranty. Please consult the warranty policy

of the surge protection device you are installing for information on product repair/replacement in the event of surge-related

damage.