Specifications
ELAN HOME SYSTEMS COM2 Communications Controller
© ELAN Home Systems 2007 • All rights reserved. 3-21
COM2 to Z•System
When connecting the COM2 to a Z•630 Multi-Room controller, use a 3.5mm mono intercon-
nect cable (ELAN IRIC for example) from the SUM Trigger Output of the COM2 to the Z•630’s
IR INPUTS Jack. The same connector is utilized for keypad connections, etc. Connect Tip
(stripe) of the interconnect cable to the Brown wire (pin 7) and Sleeve to the Brown/White wire
(pin 8) as shown.
Figure 3-27 COM2 To ELAN Z•System interconnects
COM2 to PZ6
When connecting the COM2 to a Z•630 Multi-Room controller with a PZ6 Precision Panel, use
a 3.5 mono interconnect cable from the SUM Trigger Output of the COM2 to the PZ6’s Control
Jack. Connect Tip (stripe) of the interconnect cable to the Blue wire (pin 1) and Sleeve to the
Green wire (pin 5) as shown below.
Figure 3-28 COM2 To ELAN Z•System with PZ6
COM2 Rear
Z•630 Rear
OUTPUTS
DB 1 DB 2
+12V GND +
-
+
-
+
-
+
-
NC C NO NC C NO NC C NO NC C NO+
-
+
-
1 2
POWERINPUTS RELAY 1 RELAY 2 RELAY 3 RELAY 4
AUDIO LOOP
R
L
IN OUT
PG/DB OUT
MOH IN
(MONO)
SUM PG
LEXINGTON, KY USA • MADE IN CHINA
MODEL: COM2
COMMUNICATIONS CONTROLLER
R
VCO
TRIGGERS
COM2 to Z•630 Connections
MOH OUT
PAGE & DB
INPUT
BLUE
WHITE/BROWN
BROWN
WHITE/GREEN
GREEN
WHITE/ORANGE
ORANGE
WHITE/BLUE
Tip
Sleeve
COM2 Rear
Z•630 Rear
OUTPUTS
DB 1 DB 2
+12V GND +
-
+
-
+
-
+
-
NC C NO NC C NO NC C NO NC C NO +
-
+
-
1 2
POWER INPUTS RELAY 1 RELAY 2 RELAY 3 RELAY 4
AUDIO LOOP
R
L
IN OUT
PG/DB OUT
MOH IN
(MONO)
SUM PG
LEXINGTON, KY USA • MADE IN CHINA
MODEL: COM2
COMMUNICATIONS CONTROLLER
R
VCO
TRIGGERS
COM2 to PZ6 Connections
MOH OUT
PAGE & DB
INPUT
BLUE
WHITE/BROWN
BROWN
WHITE/GREEN
GREEN
WHITE/ORANGE
ORANGE
WHITE/BLUE
Tip
Sleeve
CONTROL
PZ6