Specifications

ELAN HOME SYSTEMS COM2 Communications Controller
© ELAN Home Systems 2007 • All rights reserved. 3-15
Stereo Receiver - Tape Loop
Use stereo RCA patch cables to connect the COM2’s AUDIO LOOP IN to the Receiver’s Tape
Loop Outputs as shown. Connect the AUDIO LOOP OUT jacks to the Receiver’s Tape Loop
Inputs. This allows the COM2’s Page and Doorbell signals to be heard through the speakers
connected to the receiver.
NOTE: Only applicable when Tape Loop is active and is dependent on receiver
volume level, unless auto-sense ability is built in to the receiver.
Figure 3-20 COM2 to a Stereo Receiver Through the Tape In/Tape Out Jacks
2SDQDNØ1DBDHUDQØØØØØØØØØØØ
!5$)/,//0
2
,
). /54
0'$"/54
-/().
-/./
3@ODØ(M
+ØØØØØØØ1
3@ODØ.TS
+ØØØØØØØ1