Specifications

COM2 Communications Controller ELAN HOME SYSTEMS
3-2 © ELAN Home Systems 2007 • All rights reserved.
CAUTION: ALWAYS remove power to the COM2 along with any other
electronics equipment prior to making any connections to or from the
COM2. Set the Power Switch on the back of the COM2 to the OFF
position prior to making connections.
Figure 3-2 COM2 to Electronic Volume Control Wiring Pinout
COM2 to PVSE Electronic Volume Control Precision Panel
When connecting the COM2 to a PVSE Precision Panel, use an ELAN C45P RJ-45 to pigtail
connector. Connect the Blue Override (pin 1) wire to “+” of the COM2's VCO connector.
Connect the White/Blue Ground wire (pin 2) to the “-” of the COM2's VCO connector. Plug the
C45P into the OVERRIDE IN connector on the PVSE. See the PVSE Installation manual for
additional wiring for the PVSE and Electronic Volume Controls.
CAUTION: ALWAYS remove power to the COM2 along with any other
electronics equipment prior to making any connections to or from the
COM2. Set the Power Switch on the back of the COM2 to the OFF
position prior to making connections.
Figure 3-3 COM2 to PVSE Electronic Volume Control Precision Panel Wiring Pinout
Override
IR OUT
IR IN
N/C
N/C
+12V
GND
N/C
Electronic
Volume Control
MUTE
C45P
RJ-45 to
Pigtail
COM2
Blue
White/Blue
Orange
White/Orange
Green
White/Green
Brown
White/Brown
VCO
+-+- +-+-
To +12V
Power Supply
From IR Source
(IR Sensor,
Source Output, etc.)
To IR Device
(IR Emitter,
Zone Input, etc.)
GND
BLUE
WHITE/BLUE
ORANGE
WHITE/ORANGE
GREEN
WHITE/GREEN
BROWN
WHITE/BROWN
1
2
3
4
5
6
7
8
PIN # COLOR CODE
FRONT
CABLE
Standard ELAN RJ-45 Pin-Out
TAB
BLUE
WHITE/BLUE
ORANGE
WHITE/ORANGE
GREEN
WHITE/GREEN
BROWN
WHITE/BROWN
1
2
3
4
5
6
7
8
PIN # COLOR CODE
FRONT
CABLE
Standard ELAN RJ-45 Pin-Out
TAB
Cat-5
Blue
Wh/Blue
Orange
Wh/Orange
Green
Wh/Green
Brown
Wh/Brown
Override
N/C
N/C
N/C
N/C
N/C
Ground
N/C
VCO
+ - + - + - + -
COM2
PVSE
Override IN
OVERRIDE OVERRIDE
IN OUT