User guide
Table Of Contents
- 1 OVERVIEW
- 2 ABOUT THE USBscope50
- 2.1 General
- 2.2 USBscope50 Architecture
- 2.3 Using More Than One USBscope50
- 2.4 Input Ranges
- 2.5 Probe Compensation
- 2.6 Acquisition Modes
- 2.7 Trigger Modes
- 2.8 Trigger Position
- 2.9 Trigger Threshold
- 2.10 Data manipulation
- 2.11 Import Graph Data
- 2.12 Software Development Kit (SDK) for USBscope50
- 3 SOFTWARE INSTALLATION
- 4 HARDWARE SPECIFICATION
4. Set the timebase to 100us/div
5. Now connect your probe tip to the compensation output on
the scope. You should see a square wave something like this
or it may look more like this
6. You may find you need to connect the ground clip to either
the BNC ground or use the GND pad near the compensation
output
11
to achieve a clean waveform with minimal mains
“hum”
11
Be careful not to short-circuit the GND pad to the COMP output with the ground clip. A momentary
short circuit is not harmful but leaving a sustained short may damage the scope’s output
Elan Digital Systems Ltd. 18 USBscope50 USER’S GUIDE Iss8