Installation Guide

ManualsBrandsEl Rey ManualsStucco Mix1341

FastWall

Sanded

Description:

A. A fiber reinforced portland cement basecoat.

B. A pre-blended mix, just add water.

C. Factory prepared mixture of portland cement, lime, sand, fibers, and

other proprietary ingredients.

D. Color: Gray.

Uses:

A. FastWall can be applied over properly prepared masonry and concrete,

and code-conforming lath assemblies.

B. FastWall can be applied over a variety of substrates including expanded

polystyrene (EPS) or extruded polystyrene (XPS) foam board for added

insulation value, and wood-based and gypsum-based sheathing. Review

local code installation requirements and ICC ES Evaluation Report 5129.

C. Can be used as a component of a wall to achieve a 1-hour fire resistance

rating. Refer to applicable codes for requirements.

Available Upgrades:

A. Stucco Enhancer

B. KrakMaster™

C. Superior Bond 100

D. Premium Stucco Finish

E. Perma-Flex 400 Conditioner (w/Perma-Flex finish only)

F. Colored Primer

G. Perma-Flex Acrylic Finish

Composition:

A. Binder consists of portland cement, including fibers and proprietary

compounds for curing and workability.

B. Fiber: Synthetic.

C. Sand: ASTM C 897

Key Physical Properties:

Meets code criteria for exterior cementitious coating.

Please refer to ICC ES Legacy Report (ER-5129).

Coverage:

Approximately 27 sq. ft. (2.5 m2) at 3/8 inch (10mm) thickness per bag.

Packaging:

80lb. (36.3kg) net weight in a multi-wall bag.

A. Storage: Store off ground and protect from weather.

B. Shelf life: One year.

Working Time:

30-45 minutes after mixing, depending on conditions.

FIBER REINFORCED 

ONE COAT STUCCO BASE

FASTWALL

SANDED

80 LB. NET WT. (36.28 KG.)

Summary of content (2 pages)

PAGE 1
FastWall® Sanded Description: TM A. A fiber reinforced portland cement basecoat. B. A pre-blended mix, just add water. C. Factory prepared mixture of portland cement, lime, sand, fibers, and other proprietary ingredients. D. Color: Gray. Uses: FASTWALL FIBER REINFORCED ONE COAT STUCCO BASE SANDED 80 LB. NET WT. (36.28 KG.) ® A. FastWall can be applied over properly prepared masonry and concrete, and code-conforming lath assemblies. B.
PAGE 2
JOB PROCEDURE A. Preparation: 1. Wood-based sheathing should be gapped 1/8 inch (3mm) at all edges to accommodate thermal expansion and contraction. 2. On framed substrates cover exterior grade wood-based or exterior grade gypsum based sheathings with two layers of a minimum of a grade “D” asphaltsaturated Kraft paper. All other sheathed substrates require one layer of a minimum Grade “D” asphalt-saturated Kraft paper.