Operation Manual

Model 0311 - LANGUAGE SETTING

When a measurement is completed, the monitor will automatically say aloud the systolic

value, diastolic value and pulse rate. The default language is English.

To set language

1. Press and hold the “ sMEMO” button

until the screen displays [LLLx]

(x = 0 ~ 7), then release the button.

2. Press the “sMEMO” button to select

language.

Numbers 0 ~ 7 represents the

following languages:

0 Mute

1 English

2 French

3 German

4 Italian

5 Spanish

6 Portuguese

7 Dutch

3. Press the “ ” button to conrm the

selection and begin measurement.

TAKING MEASUREMENT

Note:

• Avoid smoking, eating or exercising for 30 minutes before

making a measurement.

• Do not move or talk during measurement.

• Measurements can be made with either arm.

Sitting correctly

1. Relax

2. Sit upright in a chair with both your feet on the oor.

3. Remove tight tting or thick clothing from you upper arm. Do not roll up your sleeve if it

is too tight.

4. Place your arm on a table so that the monitor is at the same level as your heart.

Applying the arm cu

1. Place your elbow on a table with the palm of your hand facing upward and wrap the

arm cu around your wrist.

2. Pull on the end of the cu until it wraps securely around your upper arm. Do not over

tighten the cu. Allow 1-2 cm or ½ inch between the bottom of the cu and your elbow

joint.

3. Make sure the monitor is at the same level as your heart.