Installation Guide

Critical Things

EkkoAir installation guide

EkkoSense Ltd Registered in England and Wales No. 8594313 Tower House, Lucy Tower Street, Lincoln, LN1 1XW

1. About this installation guide

This guide is aimed at EkkoSense installers and explains how to fit and configure the EkkoAir

cooling duty sensor.

2. Fit or replace the battery

To fit or replace the battery in an

EkkoAir you need to remove the

front cover. You will also need to

remove the front cover to

configure the EkkoAir.

To remove the cover, use a

screwdriver to press in the tabs

on the side and gently slide the

front off. The battery connection

is in the front and is wired to the

circuit board in the back of the

EkkoAir, so take care when

removing the front.

The EkkoAir uses a Lithium Thionyl Chloride AA 3.6V battery that fits into the rear of the

cover. Only use Tadiran SL760/S or SAFT LS14500 batteries.

Make sure that the polarity of the battery matches the + and – symbols shown next to the

battery clips for the battery connection.

The cables that connect the

battery panel to the circuit board

should be connected so that black

(negative) is the top connection

and red (positive) is the bottom

connection, as shown in the

image here.