User guide

User Guide CC3-CAJUN • Low Power CompactPCI CPU
- 32 -
EKF Elektronik GmbH • Philipp-Reis-Str. 4 • 59065 Hamm • Germany
Tel. [phone] • Fax. [phone] • [e-mail] • www.ekf.com
Installing the Board
Warning
This procedure should be done only by qualified technical personnel. Disconnect the system
from its power source before doing the procedures described here. Failure to disconnect power,
or telecommunication links before you open the system or perform any procedures can result in
personal injury or equipment damage.
Typically you will perform the following steps:
C Switch off the system, remove the AC power cord
C Attach your antistatic wrist strap to a metallic part of the system
C Remove the board packaging, be sure to touch the board only at the front panel
C Identify the related CompactPCI slot (peripheral slot for I/O boards, system slot for CPU
boards, with the system slot typically most right or most left to the backplane)
C Unlock the ejector lever by pushing the red locking bolt, move downward the ejector
lever, insert card carefully between the slot guiding rails (be sure not to damage
components mounted on the bottom side of the board by scratching neighboured front
panels), and give a moderate final press to the front panel in order to match the boards
CPCI receptacle(s) with the backplane connector(s)
C A card with additional on-board connectors requires attachment of associated cabling
now
C Lock the ejector lever, fix screws at the front panel (top/bottom)
C Retain the original packaging in case of return