Technical information

Technical Information CC0-CHILLOUT • LPC Super-I/O
- 11 -
EKF Elektronik GmbH • Philipp-Reis-Str. 4 • 59065 HAMM • Germany
Tel. +49 (0)2381/6890-0 • Fax. +49 (0)2381/6890-90 • E-Mail info@ekf.de • Internet www.ekf.de
On-Board Connectors
P1 LPC Low Pin Count interface
P2 IDE 40-pin header
P3 IDE 44-pin header
P4 Floppy disk header 34-pin
P5 Floppy disk power (opt.)
P6..P9 Fan heatsink headers (opt.)
P10 MIDI/gameport header (opt.)
P11 Midi header (opt.)
P12 Floppy disk header 26-pos. ZIF
J1 Rear I/O metric connector 5 x 25 brown key
J2 Rear I/O metric connector 5 x 22
DVI Re-routing of host CPU front panel video connector analog/digital
(opt. stacker)
RJ45 Re-routing of host CPU front panel Ethernet connector (opt. stacker)
USB Re-routing of host CPU USB front panel connector (opt. stacker)
Front Panel Connectors
No front panel connectors available with the CC0-CHILLOUT
Make use of the CC6-ACID instead if front panel I/O is required
Jumpers
J-IDE2 Enables IDE bus switches when set
Please note: In order to make use of the header P3 (IDE interface for
2.5-inch hard disk) or rear I/O IDE across J1, either connected to an
on-board HDD or an external drive, the jumper J-IDE must be set.
However, if neither P3 nor J1 is in use, J-IDE must be removed in
order to avoid reflections on the IDE bus caused by tapped signal
traces.
J-SER1 Enables the optional RS-232 transceiver (COM1) when set
If removed, the transceiver is in a high-impedance shutdown mode
J-SER2 Enables the optional RS-232 transceiver (COM2) when set
If removed, the transceiver is in a high-impedance shutdown mode