Product Manual

12
SECTION 8
OPTIONAL BATTERY INSTRUCTIONS
8.1 INSTALLATION
For complete portability, the Creamatocrit Plus will operate on a rechargeable
battery, which can be ordered as an option. The battery will need to be installed
in the device as described below and fully charged before normal operation.
1. Make certain the lid is closed and locked and the centrifuge is unplugged
from the electrical outlet. Lock the lid by firmly pressing down on the lid
tab.
2. Place the device upside down on a smooth, flat surface and on a cloth or
other protective material to prevent scratching the lid.
3. Locate the battery cover. Using a small head Phillips screwdriver, remove
the screws holding the battery cover in place. Retain the screws. Remove
the battery cover.
4. Connect the battery plug into the connector located inside the battery
cavity. Put the connector inside the hole of the housing with the connector
release tab facing up. Position the battery inside the compartment. Lay the
cable along side the battery to avoid crimping.
5. Replace the battery cover and secure with the screws provided.
6. Plug in the Creamatocrit Plus and fully charge the battery.
8.2 CHARGING THE BATTERY
The battery is always charging whenever the Creamatocrit Plus is plugged into
an electrical outlet. Since the battery cannot be overcharged, the device may
remain plugged in continuously without harm. Charge the battery overnight (or
an equivalent period of time). The percentage of remaining battery capacity
may be determined at any time by performing the following procedure.