Operating instructions

Deutsch English Français Italiano Nederlands

Trouble Shooting

1. ENTERING THE CURRENT SECURITY CODE

1.1. Press the OK-key in the control panel.

1.2. Enter the rst digit of the security code using < and > (standard setting is 9)

1.3. Press the OK-key.

1.4. Enter the second digit of the security code using < and > (standard setting is 9)

1.5. Press the OK-key.

1.6. In the display “Eu” (enrol user) is visible.

2. RESETTING TO INITIAL STANDARD SETTING

2.1. Press the >-key until “sc” is visible in the display of the control panel.

2.2. Press the OK-key.

2.3. Enter the rst digit of the security code using < and > (standard setting is 9)

2.4. Press the OK-key.

2.5. Enter the second digit of the security code using < and > (standard setting is 9)

2.6. Press the OK-key.

2.7. In the display of the control panel, “OK” will be visible for a short moment and two

red dots will appear. The system has been rest to initial standard setting.

5. TROUBLE SHOOTING

Problem Cause Solution

I am unable

to enrol a nger.

1. The nger has not been

swiped consistently over the

sensor, starting from the rst

nger joint.

2. The nger has been swiped

too softly or too strongly over

the sensor.

3. The nger has been swiped

too fast or too slowly over the

sensor.

1. Swipe the nger consistently

over the sensor starting from

the rst nger joint.

2. Swipe the nger gently, but

not too softly over the sensor.

3. Swipe the nger with mode-

rate speed over the sensor.