Operating instructions

Deutsch English Français Italiano Nederlands
23
Operation
2.4. Setting nger number: The display shows “F1”. F1 stands for nger 1.
Start counting your ngers from the little nger of the left hand.
The little nger of your right hand would then be number 10 (setting “F0”
in the display) e.g. “F7” would be the index nger of your right hand.
If a nger ID is already in use a red dot appears in the lower right hand corner of the
display.
2.5. Press the OK-key.
2.6. For ekey
®
TOCAhome, the display shows “EF” (enrol finger), as the control
panel is equipped with 1 relay.
2.7. For ekey
®
TOCAhome 3 and ekey
®
TOCAhome pc, you can now select the relay
to be activated by the selected finger.
Entering relay: “o1” is visible in the display of the control panel.
Select the desired relay by using the keys < or > and press the OK key.
Now “EF” will appear in the display.
3. ENROLLING FINGER
3.1. Once “EF” (enrol nger) is visible in the display of the control panel, you have 60
seconds to swipe your nger over the sensor, starting from the rst nger joint.
3.2. The enrolment should be done as described in chapter 4.4.
3.3. The scanner is equipped with a status display (LED), which indicates the opera-
ting mode:
Red: The nger could not be scanned successfully ;
please try again!
Orange: The device is waiting for a nger to be scanned.
Green: Successful scan
4.6. DELETING A USER FROM THE SYSTEM
1. ENTERING THE SECURITY CODE
1.1. Press the OK-key in the control panel.
1.2. Enter the rst digit of the security code using < and > (standard setting is 9)
1.3. Press the OK-key.
1.4. Enter the second digit of the security code using < and > (standard setting is 9)
1.5. Press the OK-key.
1.6. In the display “Eu” (enrol user) is visible.