Operating instructions

22
ATTENTION:
Please swipe the largest possible nger surface, starting from the rst nger joint
and applying gentle pressure. The larger the scanned nger surface, the easier it
will be for the nger to be recognised.
4.4. RECORDING A FINGER WITH THE SENSOR (SEE FIGURE 4)
It is important that the user draw his/her nger correctly across the sensor.
Note: The best results are achieved by using the middle nger while spreading the pointer
and ring ngers away from the middle nger.
Place the entire surface of the desired nger after the last joint onto the sensor.
The larger the surface area of the nger, the higher the probability will be that the nger is
recognised by the device the next time it is placed on the sensor.
The sensor is located between the two arrow indicators illuminated in green. Apply just
the right pressure (not too hard and not too soft) and drag the nger across the sensor at
medium speed. Manual workers should be aware that their nger lines are likely to wear
off, which means that a right-handed worker should record ngers on his/her left hand and
vice versa.
4.5. HOW TO ENROL A FINGER
1. ENTERING THE SECURITY CODE
1.1. Press the OK-key in the control panel.
1.2. Enter the rst digit of the security code using < and > (standard setting is 9)
1.3. Press the OK-key.
1.4. Enter the second digit of the security code using < and > (standard setting is 9)
1.5. Press the OK-key.
1.6. In the display “Eu” (enrol user) is visible.
2. SETTING ACCESS AUTHORITIES
2.1. If “Eu” is visible in the display of the control panel, press the OK-key.
2.2. Setting user number: The display shows “1“. If the user ID is already taken, a red
dot appears in the lower right hand corner of the display. Example: “1.” Select a user
ID by using the < and > keys.
2.3. Press the OK-key.
Operation