Technical data

- 8 -
Operation
4. Operation
4.1. Using the operation keys of inside unit
Programming is carried out by the usage of 4 keys:
Å Æ OK ESC
Å Æ
OK
ESC
OK
serves to enter the menu and to confirm your input.
Å
and
Æ
serves to change the values in the display and respectively for navigation respectively as shown
in the illustration of programming menu in chapter 4.3.
ESC
serves to cancel the current selection.
Program-, menu functions and display
Normal operation . (blinking)
Enrol user Eu
Delete user du
Security code setting Sc
Reset to initial settings rr
(deletes all user settings and data)
4.2. Initial operation:
Coupling between inside and outside unit
After applying power, the two dots (..) in the display of the inside unit will illuminates and the status
display of the outside unit will start blinking.
Press the
OK E
key followed by the
SC .
key The initialising process runs fully automated, whereby the
devices are coupled with each other. During this process, which lasts for approx. 15 sec. the display
shows OK.
This coupling is used to secure that the outside unit cannot be misused or changed to prevent
unauthorised persons from getting access.
After initialization is completed, a single blinking dot signals normal operation. The standard security code
which is automatically used is 99. Please change this code to your own individual code.
Note:
The exchange of the outside unit is only possible via resetting the
system to the initial settings. All data are erased in this case. You have
to carry out the initialisation once again. All fingers have to be enrolled
again in the system after this reset.